Skip to main content

Features and limitations

This topic contains information about CLI features and limitations.

The CLI has the following features and limitations:

  • Multiple concurrent CLI sessions are allowed via SSH.
  • One command is allowed per line (1024-character limit, including spaces).
  • There is no continuation character for long commands. The only editing function is the Backspace key to erase the character that you just typed.
  • The Up Arrow and Down Arrow keys can be used to browse through the last eight commands. The history command displays a list of the last eight commands, which you can then use as a shortcut to execute a command, as in the following example:
    system > history
    0 ifconfig eth0
    1 readlog
    2 readlog
    3 readlog
    4 history
    system > <span className="ph">!0</span>
    -state enabled
    -c dthens
    -i 192.168.70.125
    -g 0.0.0.0
    -s 255.255.255.0
    -n XClarity ControllerA00096B9E003A
    -r auto
    -d auto
    -m 1500
    -b 00:09:6B:9E:00:3A
    -l 00:00:00:00:00:00
    system >
  • In the CLI, the output buffer limit is 2 KB. There is no buffering. The output of an individual command cannot exceed 2048 characters. This limit does not apply in serial redirect mode (the data is buffered during serial redirect).
  • Simple text messages are used to denote command execution status, as in the following example:
    system> power on
    ok
    system> power state
    Power: On
    State: System power off/State unknown
    system>
  • The command syntax is case sensitive.
  • There must be at least one space between an option and its argument. For example, ifconfig eth0 -i192.168.70.133 is incorrect syntax. The correct syntax is ifconfig eth0 -i 192.168.70.133.
  • All commands have the -h, -help, and ? options, which give syntax help. All of the following examples will give the same result:
    system> power -h
    system> power -help
    system> power ?
  • Some of the commands that are described in the following sections might not be available for your system configuration. To see a list of the commands that are supported by your configuration, use the help or ? option, as shown in the following examples:
    system> help
    system> ?
  • In a Flex System, some settings are managed by the CMM and cannot be modified on the XClarity Controller.