Skip to main content

Replacing the media cage

Use this information to replace the media cage.

To install the media cage, complete the following steps:

  1. Read the safety information that begins on Safety and Guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the top cover (see Removing the top cover).
  4. Carefully slide the media cage into the server.
    Figure 1. Media cage installation
    Media cage installation
  5. Tighten the thumbscrew to secure the media cage onto the server.
    Figure 2. Thumbscrew
    Thumbscrew
  6. Reconnect the USB, CD/DVD and operator information/LCD panel cables to the system board first; then, route the cables as the following illustration. Remember to insert the cables into the cable clip for proper routing.
    Figure 3. Cable routing
    Cable routing
  7. Replace the top cover (see Replacing the top cover).
  8. Slide the server into the rack.
  9. Reconnect the power cords and any cables that you removed.
  10. Turn on the peripheral devices and the server.