Skip to main content

Replacing the 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane

Use this information to replace the 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane.

To install the 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane, complete the following steps:

  1. Read the safety information that begins on Safety and Guidelines.
  2. Turn off the server, and disconnect all power cords and external cables.
  3. Remove the top cover (see Removing the top cover).
  4. Pull the hard disk drives or fillers out of the server slightly to disengage them from the backplate assembly/backplane. See Removing a hot-swap hard disk driveand Removing a simple-swap hard disk drive for details.
  5. Remove the fan cage assembly (see Removing the fan cage assembly).
  6. 1 Insert the backplate assembly/backplane tabs into slots on the bottom of the drive cage at an angle; then, 2 rotate the backplate assembly/backplane toward the front the server.
    Note
    You can connect the cables to the drive backplate assembly/backplane before installing the backplate assembly/backplane onto the cage or you can connect the cables after you install the backplate assembly/backplane, if that is easier for you.
  7. 3 Push the backplate assembly/backplane to the left to engage the assembly into place.
    • For eight 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane
      Figure 1. Eight 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane
      Eight 3.5-inch simple-swap backplate assembly/hot-swap hard disk drive backplane
    • For twelve 3.5-inch hot-swap hard disk drive backplane
      Figure 2. 3.5-inch hot-swap hard disk drive backplane installation
      3.5-inch hot-swap hard disk drive backplane installation
  8. Connect the signal and power-configuration cables to the backplane and the system board. See 3.5-inch hard disk drive cable connection for more information.
  9. Reinstall the hard disk drives and filler panels (see Replacing a simple-swap hard disk drive).
  10. Replace the fan cage assembly and fans if you removed them (see Replacing the fan cage assembly and Replacing a hot-swap fan).
  11. Install the top cover (see Replacing the top cover).
  12. Slide the server into the rack.
  13. Reconnect the power cords and any cables that you removed.
  14. Turn on the peripheral devices and the server.