806f000f-220101ff : The System [ComputerSystemElementName] has detected no memory in the system. (ABR Status)
The System [ComputerSystemElementName] has detected no memory in the system. (ABR Status)
This message is for the use case when an implementation has detected that memory was detected in the system.
May also be shown as 806f000f220101ff or 0x806f000f220101ff
Severity
Error
Alert Category
Critical - Memory
Serviceable
Yes
SNMP Trap ID
41
Automatically Notify Support
No
User Response
- Make sure that one or more DIMMs are installed in the server, and resolve any other currently existing memory errors.
- If no memory fault is recorded in the logs and no DIMM connector error LEDs are lit, verify that all DIMM connectors are enabled using the Setup utility or the ToolsCenter Suite CLI.
- Re-Install all DIMMs verifying the correct population sequence, according to the service information for this product.
- Replace DIMMs.
- Recover the server firmware from the backup page: a. Restart the server. b. At the prompt, press F3 to recover the firmware. c. Update the server firmware on the primary page. Important: Some cluster solutions require specific code levels or coordinated code updates. If the device is part of a cluster solution, verify that the latest level of code is supported for the cluster solution before you update the code.
- If the problem remains, (trained technician only) replace the system board.
Give documentation feedback