Replacing the operator information panel assembly

Use this information to replace the operator information panel assembly.

1. Read the safety information that begins on Safety and Removing and replacing guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
3. Remove the top cover (see Removing the top cover).
4. Slide the operator information panel into the server until it clicks into place.
   Figure 1. Operator information panel installation
   
   
5. Inside the server, connect the operator information panel assembly cable to the system board.
   The following illustration shows the cable routing for the operator information panel.

   Figure 2. Operator information panel cable routing
   
   

   Note

   To connect the operator information panel cable on the system board, press evenly on the cable. Pressing on one side of the cable might cause damage to the cable or connector.
6. Replace the top cover (see Replacing the top cover).
7. Slide the server into the rack.
8. Reconnect the power cords and any cables that you removed.
9. Turn on the peripheral devices and the server.