Remove the chassis from the rack

Follow instructions in this section to remove the chassis from the rack.

About this task

To avoid potential danger, make sure to read and follow the safety information.

R006

CAUTION

Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended for use as a shelf.

Attention

• Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

• Use safe practices when lifting the chassis. It is advised that the task of removing or installing the chassis be executed by two persons.

CAUTION

Use safe practices when lifting the chassis.

Procedure

1. Make preparations for this task.
   1. If shipping brackets are installed on the rear of the rack, remove them.
      1. Remove the screws that secure the rear brackets.
      2. Slide the brackets toward the rear of the rack; then, remove the brackets from the rack and the chassis.

      Figure 1. Removal of shipping brackets for 29-inch or 28.31-inch deep racks
      
      

      Figure 2. Removal of shipping brackets for 29.5-inch deep racks
      
      
   2. If any nodes are installed in the chassis, power off all the nodes and disconnect all external cables from the nodes; then, remove the nodes from the chassis (see Power off the system).
      For the procedures of removing a specific node, see the links below:

      • SD530 V3: Remove a node from the chassis

      • SD550 V3: Remove a node from the chassis

      • SD535 V3: Remove a node from the chassis

      • SD520 V4: Remove a node from the chassis

      Note

      If necessary, press the release clip with a flat-head screwdriver to remove an external network cable from the rear of a 2U node.
      
      
   3. If any power supply units are installed in the chassis, remove them (see Remove a hot-swap power supply).
2. Loosen the captive screws on the front of the chassis.
3. Carefully pull the chassis out of the rack; then, remove the chassis from the rails.
   Figure 3. Chassis removal
   
   
4. Carefully lay the chassis on a flat, static-protective surface.