Skip to main content

Cabling to a Fibre Channel host network

Fibre Channel ports on the controllers are connected to Fibre Channel host network switches.

You must have contacted your network administrator for information about connecting the system to the switches.

Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.



Note
As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn it around and try again.
StepPerform on each controller module
1Cable ports 2a through 2d to the FC host switches.

2To perform other optional cabling, choose from:
3To complete setting up your system, see Completing system setup and configuration.