Hardware replacement procedures
This section provides installation and removal procedures for all serviceable system components. Each component replacement procedure references any tasks that need to be performed to gain access to the component being replaced.
- Installation Guidelines
Before installing components in your rack solution, read the installation guidelines. - Power on and power off the rack solution
Follow the instructions in this section to power on and power off the rack solution. - Blank panel replacement
Use this information to remove and install a blank panel. - Busbar replacement (trained technician only)
Follow instructions in this section to remove and install the busbar. - Compute tray replacement (trained technician only)
Follow instructions in this section to remove and install a compute tray. - Cable cartridge replacement (trained technician only)
Follow instructions in this section to remove and install a cable cartridge. - E1.S hot-swap drive replacement
Follow instructions in this section to remove and install an E1.S hot-swap drive. - Ejector bar replacement
Use this information to remove and install a ejector bar. - Leakage drip pan assembly replacement (trained technician only)
Use this information to remove and install the leakage drip pan assembly. - Management switch replacement (trained technician only)
Follow instructions in this section to remove and install a management switch. - Manifold replacement (trained technician only)
Follow instructions in this section to remove and install a manifold. - M.2 drive replacement (trained technician only)
Follow instructions in this section to remove and install the M.2 drive. - NVLink switch tray replacement (trained technician only)
Follow instructions in this section to remove and install an NVLink switch tray. - PMC (Power Management Controller) replacement
Use this information to remove and install a hot-swap PMC (Power Management Controller). - Power shelf replacement (trained technician only)
Follow instructions in this section to remove and install a power shelf. - Power supply unit replacement
Use this information to remove and install a hot-swap power supply unit. - Rail replacement (trained technician only)
Use this information to remove and install a rail. - Complete the parts replacement
Go through the checklist to complete parts replacement
Give documentation feedback