Skip to main content

Enclosure and SMM

Use the information in this topic to understand the enclosure and SMM settings.

Enclosure​

Click the Reseat Enclosure button, the enclosure will be powered off immediately and be powered on after 10 seconds.
Note
When you reseat the enclosure, your web browser will lose contact with the SMM for several minutes.

SMM​

When configuring the SMM, following options are available:

  • Check Log Status LED: Shows “On” when critical event occurs and “Off” when system critical event is de-asserted.

  • Locator LED Accept Mode: Show “On” or “Off”.

  • Locator LED: Choose Locator Led behavior, click Launch button after making configuration changes.

    • Turn Off: Turn off the ID LED on all the compute nodes in the enclosure and enter accept mode, in which the LED behavior is determined by the node ID LEDs.

      Note
      Locator LED is set as accept mode by default.

    • Turn On: All the node ID LEDs will be on except the blinking ones, which will remain blinking.

    • Blink: All the node ID LEDs will be blinking regardless of previous status.

  • Restart SMM: Click the Restart button to restart the SMM, your web browser will lose contact with the SMM for 2 to 3 minutes. When the SMM is back online, you may need to log in again.