Skip to main content

Firmware

The page provides firmware information and firmware update.

This page provides three main functions:

SMM​

An overview of the active and inactive firmware information is provided.

  • Active Firmware: Overview of active firmware information.

  • inactive Firmware: Overview of inactive firmware information.

SMM Firmware Update​

The firmware update process comes in three steps.

  • Step 1: Click “Add file” and select a firmware image file, then click “Upload”.

  • Step 2: Once the valid firmware image has been uploaded, the firmware information will be displayed. Select “SMM_Primary” or “SMM_Backup” as the target that will be used for the update process.

    The following actions can also be performed:

    • Enable Secure Rollback: Click the checkbox to roll back to the previous firmware version. The function is set as “Disabled” by default.

    • Preserve Settings: Check to preserve the setting. The configuration will be kept and SMM3 will be reboot after the firmware is updated. If you unclick the checkbox, SMM3 configurations will be reset to factory default setting after the firmware is updated.

    Attention
    Do not close the browser or change to another page during the upload process.

  • Step 3: Click “Update” to start the update. The update progress will be shown and may take about 3-5 minutes to complete the update.

    Attention

    • Do not close the browser during the update process, once the progress reaches 100%, SMM3 will atomically restart and users need to log in again to access the SMM3 web interface.

PCS Firmware Update​

Steps to update PCS firmware. To manually apply update for PCS firmware, complete the following steps:

  • Step 1: Click “Add file” and select a firmware image file, then click “Upload”.

  • Step 2: Once the valid firmware image has been uploaded, the firmware information will be displayed. Check the PCS’s that will used as the target for the update process. All the available PCS will be selected by default.

    Attention
    Do not close the browser during the upload process.

  • Step 3: Click “Update” to start the update. The update progress will be shown and may take a few minutes depending on the number of PCS number that needs to be updated.

    Attention
    Do not close the browser during the update process.