Nodes

Display nodes information, configure node restore policy, and provide restart XCC and reseat node actions.

• Node checkbox: Launch selected node to show available action item: restart XCC / Reseat Node.

• Nodes: Indicates server slot numbering and show the information of the present node. Depending on the type and the location of the node installed, the number is from 1a to 8d.

• XCC IP 1 / XCC IP 2: Show XCC IP information. Click the XCCIP link to open the XCC webpage.

• Status:

  • No Permission: Indicates node has not granted power permission and cannot power on.

  • Fault: Indicates node has power fault and cannot be powered on.

  • Power On: Indicates node is power on.

  • Power Off: Indicates node is power off.

• Edit: To configure power restore policy. Select either “Power off” or “Last State” for the restore policy. It indicates the mode of the operation after the power failure occurred.

  • Power off: Node remains power off when power is restored.

  • Last State: Node will be powered on automatically and restore to the status before the power failure occurred.

  Make sure to click on “Save” to activate the setting.
  Note

  Use this configuration when ‘Current Power Status’ is Good.

To perform Restart XCC, Reseat Node through System Management Module 3 click the following button:

• Restart XCC: Click the “Restart XCC” button to restart node’s XCC.

• Reseat Node: Click the “Reseat Node” button to power cycle entire node.