Skip to main content

Parameter in IPMI Command Contents

The section provides detailed parameters in IPMI command contents.

SET LAN CONFIG PARAM​

NetFn

0x0C

CMD

0x01

Request data

  • Byte 1 - Channel number
  • Byte 2 - Parameter Selector
  • Byte [3:N] - Configuration Parameter

Response data

Byte 1 - Completion Code

Comments

[Request data]

Byte 2 - Parameter Selector

Byte [3:N] - Configuration Parameter
[Response data]
Byte 1 - Completion Code
  • 0x80: Parameter not supported.
  • 0x81: Attempt to set the ‘set in progress’ value when not in the ‘set complete’ state.
  • 0x82: Attempt to write read-only parameter.
  • 0x83: Attempt to read write-only parameter.

GET LAN CONFIG PARAM​

NetFn

0x0C

CMD

0x02

Request data

  • Byte 1 - Channel number
  • Byte 2 - Parameter Selector
  • Byte 3 - Set Selector
  • Byte 4 - Block Selector

Response data

  • Byte 1 - Completion Code
  • Byte 2 - Parameter Revision
  • Byte [3:N]: Configuration Parameter

Comments

[Request data]
Byte 2 - Parameter Selector
Byte 3 - Set Selector
  • 0x00: if parameter doesn’t use a set selector.
Byte 4 - Block selector
  • 0x00: if parameter doesn’t use a block selector.