跳到主要内容

FQXSFPU0030N : A firmware fault has been detected in the UEFI image.

A firmware fault has been detected in the UEFI image.

This message is reported when a firmware fault has been detected in the UEFI image.

Severity​

Error

User Action​

Complete the following steps:

  1. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this error.
  2. Reflash UEFI image.
  3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-install options one at a time to locate the problem.
  4. If the problem persists, save customer's UEFI configurations, then remove and re-install CMOS battery for 30 seconds to clear CMOS contents. If it boots successfully, then restore system settings.
  5. If the problem persists, collect service data logs and contact Lenovo Support.
    Note
    The solution for this error may involve a system board replacement. If TPM encryption has been enabled, back up TPM Encryption Recovery Key.