Skip to main content

System-board switches

The following illustration shows the location and description of the switches.

Important
  1. If there is a clear protective sticker on the switch blocks, you must remove and discard it to access the switches.
  2. Any system-board switch or jumper block that is not shown in the illustrations in this document are reserved.
Figure 1. Location of the switches, jumpers, and buttons on the system board
Location of the switches, jumpers, and buttons on the system board

The following table describes the jumpers on the system board.

Table 1. Jumper definition.

The jumper description table with one level of row and column headers.

Switch blockSwitchSwitch nameUsage description
OpenClose
S182XClarity Controller boot backupNormal (default)The compute node will boot by using a backup of the XClarity Controller firmware.
3XClarity Controller force updateNormal (default)Enables XClarity Controller force update
4TPM physical presenceNormal (default)Indicates a physical presence to the system TPM
S191System UEFI backupNormal (default)Enables system BIOS backup
2Password override jumperNormal (default)Overrides the power-on password
3CMOS clear jumperNormal (default)Clears the real-time clock (RTC) registry
Important
  1. Before you change any switch settings or move any jumpers, turn off the solution; then, disconnect all power cords and external cables. Review the information in Safety Information page, Installation Guidelines, Handling static-sensitive devices, and Power off the compute node.
  2. Any system-board switch or jumper block that is not shown in the illustrations in this document are reserved.