Skip to main content

Internal cable routing

Some of the components in the compute node have internal cable connectors.

Attention
  • Some options, such as RAID adapter and backplanes, might require additional internal cabling. See the documentation that is provided for the option to determine any additional cabling requirements and instructions.
  • Strictly observe the following instructions to avoid damaging cable sockets on the system board. Any damage to the cable sockets might require replacing the system board.

    • Connect cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.

    • To disconnect cables from the system board, do as follows:

      1. Press and hold all latches, release tabs, or locks on cable connectors to release the cable connectors.

      2. Remove the cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.
        Note
        The cable connectors might look different from those in the illustration, but the removal procedure is the same.