Skip to main content

Install the cross braces

Use this information to install the cross braces.

About this task

Attention

Procedure

  1. Install the front and the rear cross braces (12 Phillips #1 screws and 2 captive screw).
    Figure 1. Cross brace installation (SD650-I V3)
    Cross brace installation (SD650-I V3)
  2. Install the two brackets and secure them with seven screws.
    Figure 2. Bracket installation
    Bracket installation
After you finish

  1. Install the tray cover. See Install the tray cover.

  2. Install the tray into the enclosure. See Install a DWC tray in the enclosure.

  3. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.

Demo video

Watch the procedure on YouTube