Parts list
Use the parts list to identify each of the components that are available for your solution.
Go to Lenovo Data Center Support and navigate to the support page for your solution.
Click .
Enter the serial number to view a listing of parts for your solution.
It is highly recommended that you check the power summary data for your solution using Lenovo Capacity Planner before purchasing any new parts.
T1: Tier 1 customer replaceable unit (CRU). Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
T2: Tier 2 customer replaceable unit (CRU). You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
F: Field replaceable unit (FRU). FRUs must be installed only by trained service technicians.
C: Consumable and Structural parts. Purchase and replacement of consumable and structural parts (components, such as a filler or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.
SD650-N V3 parts list
| Index | Description | Type |
|---|---|---|
For more information about ordering parts:
| ||
| 1 | Tray cover | F |
| 2 | Screw | F |
| 3 | Rear cross brace | F |
| 4 | Power distribution board (GPU node) | F |
| 5 | Tray | F |
| 6 | Water loop | F |
| 7 | Power distribution board (compute node) | F |
| 8 | DIMM comb | F |
| 9 | DIMM cover | F |
| 10 | Memory module | F |
| 11 | Memory module filler | F |
| 12 | DIMM tool | F |
| 13 | Conduction plate kit | F |
| 14 | OSFP module | F |
| 15 | VR water clamp plate | F |
| 16 | Venting hole block | F |
| 17 | VR water loop trough | F |
| 18 | M.2 drive | F |
| 19 | Front cross brace | F |
| 20 | Cross brace–cable cover | F |
| 21 | Processor | F |
| 22 | System board | F |
| 23 | GPU board assembly (GPU board installed with four GPUs) | F |
| 24 | GPU (SXM 5) | F |
| 25 | Drive cage | F |
| 26 | Drive cage with conduction plate | F |
| 27 | 7mm drive | F |
| 28 | Processor retainer | F |
| 29 | GPU board | F |
| 30 | Carrier board (for network board) | F |
| 31 | Miscellaneous Parts Kit | F |
| 32 | CMOS battery (CR2032) | C |
| 33 | Network board | F |
| 34 | SD650-N Water loop Service Kit | F |
| 35 | SD650-N V3 node miscellaneous kit | F |
| 36 | Thermal pad kit (gap pad or putty pad) | F |
| 37 | E3.S cage and conduction plate | F |
| 38 | GPU PCM application jig | F |
| 39 | Bus bar | F |
| 40 | Blank bezel filler without venting | F |
| 41 | Blank bezel filler | F |
| 42 | M.2 backplane assembly | F |
| 43 | Cable | F |