Skip to main content

Network problems

Use this information to resolve issues related to networking.

Cannot wake server using Wake on LAN​

Complete the following steps until the problem is solved.

  1. Check the system event log and resolve any related problems. To view the system event log, go to Setup Utility and select Security > System Event Log > View System Event Log.

  2. Change the Wake on LAN setting. Go to Setup Utility and select Power > Automatic Power On > Wake on LAN. The default setting is automatic. Change it to primary.

  3. Remove and reinstall the I/O module board.

  4. Turn off the server and disconnect it from the power source; then, wait 10 seconds before restarting the server.

  5. If the problem recurs, replace the I/O module board.

Could not log in using LDAP account with SSL enabled​

Complete the following steps until the problem is resolved:

  1. Make sure that the license key is valid.

  2. Generate a new license key and log in again.