Install the intrusion switch cable
Use this information to install the intrusion switch cable.
Before you install the intrusion switch cable, complete the following steps:
- Read the following sections to ensure that you work safely.
Turn off the server. Disconnect the power cords and all external cables (see Power off the server).
Insert the intrusion switch cable through the hole on the carrier.
Figure 1. Intrusion switch cable installation
- Lower the intrusion switch carrier into the chassis and press the intrusion switch carrier down until it is securely seated.
- Fasten the two screws.
- Connect the cable to the connector and press it down until it clicks.Figure 2. Intrusion switch installation
After you install the intrusion switch, complete the following steps:
Install the node if needed (see Install a node).
Reconnect power cords and all external cables.