Skip to main content

Install the VGA cable (3.5-inch drive model)

Use this information to install the VGA cable for the 3.5-inch drive model.

About this task

Attention
  • Read the following section(s) to ensure that you work safely.

  • Turn off the server. Disconnect the power cords and all external cables. See Power off the server.

  • If the server is installed in a rack, remove the server from the rack.

Procedure

  1. Install the VGA cable.
    Figure 1. VGA cable installation
    VGA cable installation
    1. Insert the VGA cable into the slot on the front chassis.
    2. Install the screws to secure the VGA cable.
  2. Push the VGA cable cover into the slot until the clips are locked.
    Figure 2. VGA cover installation
    VGA cover installation

After you finish

  1. Connect the VGA cable. See Front panel cable routing.

  2. Install the top cover onto the server. See Install the top cover.

  3. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube