Install the VGA cable (2.5-inch drive model)
Use this information to install the VGA cable for the 2.5-inch drive model.
About this task
Attention
- Read the following section(s) to ensure that you work safely.
Turn off the server. Disconnect the power cords and all external cables. See Power off the server.
If the server is installed in a rack, remove the server from the rack.
Procedure
Install the VGA cable.
Figure 1. VGA cable installation
Insert the VGA cable into the front I/O assembly.
Install and fasten two screws to secure the VGA cable.
After you finish
Install the front operator panel (2.5-inch drive model). See Install the front operator panel (2.5-inch drive model).
Install the top cover onto the server. See Install the top cover.
Complete the parts replacement. See Complete the parts replacement.
Demo video
Give documentation feedback