Skip to main content

Install an intrusion switch

Use this information to install an intrusion switch.

About this task

Attention

  • Read Installation guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the intrusion switch to any unpainted surface on the outside of the server. Then, take the intrusion switch out of the package and place them on a static-protective surface.
  2. Insert the intrusion switch and push it in the direction as shown until it is fully seated.
    Figure 1. Intrusion switch installation
    Intrusion switch installation

After you finish

  1. Connect the cable of the intrusion switch to the intrusion switch connector on the system board by referring to Intrusion switch cable routing. For the location of the intrusion switch connector, refer to System board.

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube