Skip to main content

Internal cable routing

Some of the components in the server have internal cables and cable connectors.

To connect cables, observe the following guidelines:

  • Turn off the server before you connect or disconnect any internal cables.

  • See the documentation that comes with any external devices for additional cabling instructions. It might be easier for you to route cables before you connect the devices to the server.

  • Cable identifiers of some cables are printed on the cables that come with the server and optional devices. Use these identifiers to connect the cables to the correct connectors.

  • Ensure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.

  • Ensure that the relevant cables pass through the cable clips.

Attention
Strictly observe the following instructions to avoid damaging cable sockets on the system board. Any damage to the cable sockets might require replacing the system board.

  • Connect cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.

  • To disconnect cables from the system board, do as follows:

    1. Press and hold all latches, release tabs, or locks on cable connectors to release the cable connectors.

    2. Remove the cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.
      Note
      The cable connectors might look different from those in the illustration, but the removal procedure is the same.