Skip to main content

Remove the intrusion switch

Use this information to remove the intrusion switch.

About this task

  • Read Installation Guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. If the server is installed in a rack, extend the server from the rack.
  2. Remove the top cover. See Remove the top cover.
  3. Remove the intrusion switch assembly from the fan cage as shown.
    Note
    The blowup in the illustration shows the fan cage upside down.
    Figure 1. Intrusion switch removal
    Intrusion switch removal

    1. Move the intrusion switch connector forward to disengage it from the keyhole.
    2. Release the intrusion switch cable from the cable clip.
    3. Slide and pull the intrusion switch to remove it from the holder.

After you finish

  1. Install a new intrusion switch. See Install the intrusion switch.

  2. If you are instructed to return the defective component, follow all packaging instructions and use any packaging materials that are provided.

Demo video

Watch the procedure on YouTube