Skip to main content

Install the intrusion switch

Follow instructions in this section to install the intrusion switch.

About this task

  • Go over Installation Guidelines to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.


  1. Align the intrusion switch with the slot next to the power supply bays, and push it in.
    Figure 1. Installing the intrusion switch

  2. Connect the cable to the system board. See System board connectors to locate the connector on the system board.

After this task is completed

Proceed to complete the parts replacement (see Complete the parts replacement).