Skip to main content

Remove the flash power module

Follow instructions in this section to remove the flash power module.

About this task

Attention
  • Go over Installation Guidelines to ensure that you work safely.

  • Turn off the server and peripheral devices and disconnect the power cords and all external cables (see Power off the server).

  • If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover, or remove the server from the rack.

Procedure

  1. Make preparations for this task.
    1. Remove the top cover (see Remove the top cover).
    2. Disconnect the cable from the flash power module to be removed.
      Figure 1. Disconnecting the cable from the flash power module

  2. Press on the retaining latch to disengage the flash power module; then, remove the module.
    Figure 2. Removing the flash power module

After this task is completed

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.