Install the intrusion switch

Follow this procedure to install the intrusion switch.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Before installing the intrusion switch:

1. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

To install the intrusion switch, complete the following steps:

1. Align the intrusion switch to the chassis as illustrated; then, secure it with a screw.
   Figure 1. Installing the intrusion switch
   
   
2. Connect the intrusion switch cable to the system board. To locate the connector on the system board, see System board components.