System board jumpers

The following illustration shows the location of the jumpers on the server.

Figure 1. System board jumpers

Table 1. Jumper description

Jumper name	Jumper setting
1 CLR_CMOS	Pin 1 and 2: default Pin 1 and 3: clear CMOS

Important

• Before you move the jumpers, turn off the server. Then, disconnect all power cords and external cables. Do not open your server or attempt any repair before reading and understanding the following information:

  • Safety Information page

  • Handling static-sensitive devices

• Any system-board switch or jumper block that is not shown in the illustrations in this document are reserved.