Skip to main content

Remove the backplane for four 2.5-inch hot-swap drives

Use this information to remove the backplane for four 2.5-inch hot-swap drives.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening

Before removing the backplane for four 2.5-inch hot-swap drives:

  1. Remove the server cover. See Remove the server cover.

  2. Remove the air baffle. See Remove the air baffle.

  3. If the Fan 3 impedes your access to the backplane, remove it. See Remove a front fan.

  4. Remove all the installed drives and fillers (if any) from the drive bays. See Remove a hot-swap drive.

  5. Record the cable connections on the backplane and then disconnect all cables from the backplane. For information about the backplane cable connection, see Hot-swap-drive backplane.

To remove the backplane for four 2.5-inch hot-swap drives, complete the following steps:

Watch the procedure
  • A video of this procedure is available at YouTube
Figure 1. Removal of the backplane for four 2.5-inch hot-swap drives
Removal of the backplane for four 2.5-inch hot-swap drives

  1. Lift the release tab to disengage the backplane.
  2. Remove the backplane from the chassis.
If you are instructed to return the old backplane, follow all packaging instructions and use any packaging materials that are provided.