Skip to main content

Install the CMOS battery (CR2032)

Use this information to install the CMOS battery (CR2032).

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S004
Attention
CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

S005
Attention
CAUTION
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it only with the approved part. Recycle or discard the battery as instructed by local regulations.
Attention
  • Read Installation guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Consider the following when replacing the CMOS battery in the server:
  • When replacing the CMOS battery, you must replace it with another CMOS battery of the same type from the same manufacturer.

  • After replacing the CMOS battery, make sure to reconfigure the server and reset system date and time.

  • Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly to avoid possible danger. If you install the CMOS battery, you must adhere to the following instructions.

  • If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal components, be aware of the following environmental consideration. Batteries and accumulators that contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper manner.

Procedure

Install the CMOS battery.
Figure 1. Installing the CMOS battery
Installing the CMOS battery
  1. Place the CMOS battery on top of the socket with the positive (+) symbol facing up.
  2. Push the battery into the socket until it clicks in place.

After you finish

  1. Reinstall the air baffle. See Install the air baffle.

  2. Reinstall all the flash power modules. See Install a flash power module.

  3. Reinstall the server cover. See Install the server cover.

  4. Complete the parts replacement. See Complete the parts replacement.

  5. Reset date, time, and all the passwords.

Demo video

Watch the procedure on YouTube