Replacing storage block hardware

Procedures for replacing the Lenovo ThinkAgile CP storage block hardware.

This section provides installation and removal procedures for all serviceable ThinkAgile CP system components. Each component replacement procedure references any tasks that need to be performed to gain access to the component being replaced.

Refer to Roles and responsibilities to determine who can perform these procedures.

For more information about ordering parts, go to:http://datacentersupport.lenovo.com/us/en/products/storages/thinksystem/sr630/7x01/parts.

• Replacing storage network cables or transceivers
  This section describes how to replace storage network cables or transceivers.
• Hot-swap drive replacement
  This section covers information about replacing a hot-swap drive.
• Hot-swap power supply replacement
  Use this information to remove and install a hot-swap power supply.
• Hot-swap storage controller replacement
  Use this information to remove and install a storage controller. You can remove or install a storage controller without turning off the storage, which helps you avoid significant interruption to the operation of the system.
• Enclosure replacement
  Use this information to replace a storage enclosure.
• Complete the parts replacement
  Use this information to complete the parts replacement.