Skip to main content

Set storage array redundancy mode

The set storageArray redundancyMode command sets the redundancy mode of the storage array to either simplex or duplex.

Supported Arrays​

This command applies to an individual DE2000H, DE4000H, DE4000F, DE6000H, or DE6000F storage array.

Roles​

To execute this command on an storage array, you must have the Storage Admin role.

Syntax​

set storageArray redundancyMode=(simplex | duplex)

Parameter​

ParameterDescription
redundancyMode Use simplex mode when you have a single controller. Use duplex mode when you have two controllers.