Skip to main content

Installing the RFID tag

Use this information to install the RFID tag on the bezel.

Before you install the RFID tag, read Safety and Installation guidelines.

To install the RFID tag, complete the following steps.


Graphic illustrating the installation of a SAS hot-swap storage drive

  1. Make sure that the surface you are installing the tag on is thoroughly clean and dry.
  2. Remove the backing from the base to expose the adhesive.
  3. Position the RFID tag over the ID label on the front of the bezel.
  4. Press the RFID tag securely against the bezel and hold firmly in place for 30 seconds.
    Notes
    • Allow 30 minutes before pivoting the RFID tag.
    • Allow 24 hours to achieve near maximum adhesion.