Skip to main content

Replacing the operator information panel assembly

Use this information to replace the operator information panel assembly.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To install the operator information panel assembly, complete the following steps.
  1. Guide the operator information panel assembly into position on top of the DVD drive housing. Make sure that the LEDs and the USB connectors are aligned with the openings in the bezel and that the screw holes in the operator information panel align with the screw holes in the top of the DVD bay housing.
  2. Use the screws that you removed in Removing the operator information panel assembly to secure the operator information panel assembly on the DVD bay housing.
  3. Connect the signal cable to the operator information panel board.
  4. Install the server top cover (see Replacing the cover ).
  5. Reconnect the power cord and any cables that you removed.
  6. Turn on all attached devices and the server.

If you have replaced a server component or installed an optional device in the server, you need to reconnect the power cords and all external cables, and turn on the server and peripheral devices.