Skip to main content

Replacing the RAID adapter battery or flash power module holder

Use this information to replace the RAID adapter battery or flash power module holder in the server.

Note
RAID adapter battery or flash power module holder is only supported in the 2.5-inch models.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To replace the RAID adapter battery or flash power module holder, complete the following steps:

  1. Align the holder and place the holder on the system tray.
    Figure 1. RAID adapter battery or flash power module holder installation
    RAID adapter battery or flash power module holder installation
  2. Fasten the two screws come with the holder and make sure that the holder is secured firmly on the system tray.
  3. Reinstall the remotely installed RAID adapter battery or flash power module (see Replacing a RAID adapter battery or flash power module).
  4. Install the retainer.
  5. Reinstall the cover (see Replacing the cover).

What to do next

  1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
  2. Reconnect the power cords and any cables that you removed.
  3. Turn on the peripheral devices and the server.