Skip to main content

Removing the RAID adapter battery or flash power module holder

Use this information to replace the RAID adapter battery or flash power module holder in the server.

Note
RAID adapter battery or flash power module holder is only supported in the 2.5-inch models.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To remove the RAID adapter battery or flash power module holder, complete the following steps:

  1. Remove the cover (see Removing the cover).
  2. Remove the retainer.
  3. Remove the remotely installed RAID adapter battery or flash power module (see Removing a RAID adapter battery or flash power module).
  4. Loosen the two screws from the system tray.
    Figure 1. RAID adapter battery or flash power module holder removal
    RAID adapter battery or flash power module holder removal
  5. Lift the holder up to remove the holder from the system tray.

If you are instructed to return the server component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.