Skip to main content

Removing a RAID adapter battery or flash power module

Use this information to remove a RAID adapter battery or flash power module in the server.

Note
RAID adapter battery or flash power module is only supported in the 2.5-inch models.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

If a RAID adapter battery or flash power module is installed near the fan cage and you need to remove it, complete the following steps:

  1. Remove the cover (see Removing the cover).
  2. Remove any cable covering or obstructing the holder before opening the holder.
  3. Remove the retainer then pull the release tab outward and unlock the retention clip.
    Figure 1. RAID adapter battery or flash power module removal
    RAID adapter battery or flash power module removal
    Attention
    Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
  4. Lift the battery or flash power module up to remove the battery or flash power module from the holder.
  5. Disconnect the cable from the cable connector on the battery or flash power module.

If you are instructed to return the server component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.