Installing a DIMM

Use this information to install a DIMM.

1. Unlock and remove the left-side cover (see Removing the left-side cover).
2. Remove the air baffle if installed (see Removing the air baffle).
3. Open the retaining clip on each end of the DIMM connector.
   Attention

   To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently.
   Figure 1. DIMM installation
   
   
4. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the outside of the server. Then, remove the DIMM from the package.
5. Turn the DIMM so that the alignment slot align correctly with the alignment tab.
6. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector (see System-board internal connectors) for the locations of the DIMM connectors).
   Figure 2. Insert DIMM into connector
   
   
7. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector.
   Note

   If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it.