| Unable to wake the server using the Wake on LAN feature. | - If you are using the dual-port network adapter and the server is connected to the network using Ethernet 5 connector, check the system-error log or IMM2 system event log (see Event logs), make sure:
- The room temperature is not too high (see Server features and specifications).
- The air vents are not blocked.
- The air baffle is installed securely.
- Reseat the dual-port network adapter (see Removing an adapter and Installing an adapter).
- Turn off the server and disconnect it from the power source; then, wait 10 seconds before restarting the server.
- If the problem still remains, replace the dual-port network adapter.
|
| Wake on Lan feature is in disable mode. | - Turn on the server.
Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes active after the power-on LED flashes slowly. - When prompted, <F1 Setup> is displayed, press F1. If you have set an administrator password, you are prompted to type the password.
- Under System Configuration and Boot Management, select System Settings.
- Under System Settings, select Network.
- Under Network, select the port number.
- Under the chosen port number, select Intel (R) I350 Gigabit Network Connection.
- Under Main Configuration Page, select NIC configuration.
- Under NIC configuration, change the Wake on Lan function from Disabled to Enabled.
- Press ESC several times until the System Configuration and Boot Management window is displayed.
- Select Save Setting.
- Turn off the server and disconnect it from the power source. You must disconnect the system from ac power to enable the Wake on Lan function.
|
| Log in failed by using LDAP account with SSL enabled. | - Make sure the license key is valid.
- Generate a new license key and log in again.
|