Installing the operator information panel assembly

Use this information to install the operator information panel assembly.

1. Read the safety information that begins on Safety and Installation guidelines.
2. From the front of the server, slide the operator information panel into the server until it clicks into place.
3. Inside the server, connect the cable to the rear of the operator information panel assembly.
   Figure 1. Operator information panel assembly installation
   
   

   The following illustration shows the cable routing for the operator information panel. The following notes describe additional information when you install the cable:

   • You may remove the optional optical drive cable to obtain more room before you install or remove the operator information panel cable.
   • To connect the operator information panel cable on the system board, press evenly on the cable. Pressing on one side of the cable might cause damage to the cable or connector.
   • The operation information panel cable should go in between the Video/USB cable (on the bottom) and the CD/DVD cable (on the top) when all three cables are installed in the server.

   Figure 2. Operator information panel assembly cable connection
   
   
4. Install the cover (see Installing the cover).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.