Skip to main content

Replacing a RAID adapter battery or flash power module holder

Use this information to replace a RAID adapter battery or flash power module holder.

To install a RAID adapter battery or flash power module holder, complete the following steps:

Note
The following steps only apply to 2.5-inch hard disk drive server models. The RAID adapter battery or flash power module holder cannot be removed for 3.5-inch hard disk drive server models.
  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords and external devices; then, remove the cover (see Removing the cover).
  3. Slide the tray until it snaps into position in the chassis.
    Figure 1. RAID adapter battery or flash power module holder installation
    RAID adapter battery or flash power module holder installation
  4. Reinstall the cover (see Replacing the cover).
  5. Slide the server into the rack.
  6. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.