Removing a RAID adapter battery or flash power module holder

Use this information to remove a RAID adapter battery or flash power module holder.

To remove a RAID adapter battery or flash power module holder, complete the following steps:

Note

The following steps only apply to 2.5-inch hard disk drive server models. The RAID adapter battery or flash power module holder cannot be removed for 3.5-inch hard disk drive server models.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the cover (see Removing the cover).
3. Remove the RAID adapter battery or flash power module (see Removing a RAID adapter battery or flash power module).
4. To remove the holder, press the blue release tab; then, slide the holder away from the chassis.
   Figure 1. RAID adapter battery or flash power module holder removal
   
   

If you are instructed to return the RAID adapter battery or flash power module holder, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.