Skip to main content

W.3808002 : [W.3808002] An error occurred while saving UEFI settings to the IMM.

[W.3808002] An error occurred while saving UEFI settings to the IMM.

Error Updating System Configuration to IMM

Severity​

Warning

User Response​

Complete the following steps:

  1. Use F1 Setup, Verify Settings and Save Settings to recover settings.
  2. Reset IMM.
  3. Remove and re-install power from the system. Then reboot the entire system.
  4. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
  5. Reflash IMM Firmware.
  6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
  7. (Trained Service technician only) Replace the system board.