Configuring the chassis by using the CMM

Follow the instructions in this section to establish an Ethernet connection to the Chassis Management Module and use the CMM web interface to configure the chassis.

Note

• You must use the Chassis Management Module to establish user accounts and to configure IP addresses for the CMM and the I/O modules.
• If you have multiple chassis on the management network, you must establish user accounts and configure the IP addresses for each chassis.
• Use the Chassis Management Module web interface to complete the chassis configuration.

For more information about using the Chassis Management Module web interface to configure the chassis, see the "Flex System Chassis Management Module: User’s Guide".

• CMM network access tag
  Information that you need to initially connect to the CMM is on the network access tag.
• IPv6 addressing for initial connection
  When you use IPv6 addressing, use the IPv6 link-local address to complete the initial connection to the CMM.
• Ethernet connection
  Use these instructions to connect to the CMM through an Ethernet connection to use the CMM web interface.