Skip to main content

Removing the front handle

Use this information to remove the front handle.

Before you remove the front handle, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface with the cover side down, orienting the compute node with the bezel pointing toward you.

To remove the front handle, complete the following steps.
Figure 1. Removal of the front handle
Graphic illustrating the removal of the front handle

  1. Locate the screw that attaches the handle to the compute node.
  2. Using a Phillips screwdriver, remove the screw from the front handle and save the screw in a safe place. Use the same screw when you install a front handle.
If you are instructed to return the front handle, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.