Install the enclosure on the slide rails
Use this information to install the enclosure on the slide rails.
Attention
Before you install the enclosure, make sure that all compute nodes and the shuttle are removed out of the enclosure.
To install the enclosure on the rails, complete the following steps.
| 1 Pull the slide rails forward until the rails click into place.2 Push up the front latches.3 Pull the slides all the way out. Figure 1. Slides  | |
| 4 Carefully lift the enclosure. Note Make sure all compute nodes and the shuttle are removed out of the enclosure. Figure 2. Enclosure  | 5 Tilt and lower the enclosure; then, push the slides toward the enclosure and make sure the farthest nailheads go into the slots on the slides.6 Slowly lower the enclosure down and make sure the other 3 nailheads slip into the slots. Attention You can only install the enclosure successfully when the slides are fully extended. Figure 3. Enclosure installation  |
Give documentation feedback