DC Persistent Memory Module (DCPMM) setup
Follow the instructions in this section to complete required setup before installing DCPMMs for the first time, determine the most suitable configuration, and install memory modules accordingly.
Complete the following steps to finish system setup to support DCPMMs, and install the memory modules according to the designated combination.
Update the system firmware to the latest version that supports DCPMMs (see Update the firmware).
Make sure to meet all the following requirements before installing DCPMMs.
All the DCPMMs that are installed must be of the same part number.
All the DRAM DIMMs that are installed must be of the same type, rank, and capacity with minimum capacity of 16 GB. It is recommended to use Lenovo DRAM DIMMs of the same part number.
- Refer to DC Persistent Memory Module (DCPMM) installation order to determine the most suitable combination and the following:
- Number and capacity of the DCPMMs and DRAM DIMMs to install.
- Check if the presently installed processors support the combination. If not, replace the processors with ones that support the combination.
Based on the determined DCPMM combination, acquire the DCPMMs, DRAM DIMMs and processors if necessary.
Replace the processors if necessary (see Processor replacement).
Remove all the memory modules that are installed (see Remove a DIMM).
Follow the slot combination in DC Persistent Memory Module (DCPMM) installation order to install all the DCPMMs and DRAM DIMMs (see Install a DIMM).
Disable security on all the installed DCPMMs (see Configure DC Persistent Memory Module (DCPMM)).
Make sure the DCPMM firmware is the latest version. If not, update it to the latest version (see Updating firmware on managed devices with LXCA).
Configure DCPMMs so that the capacity is available for use (see Configure DC Persistent Memory Module (DCPMM)).