System configuration
Complete these procedures to configure your system.
- Set the network connection for the Lenovo XClarity Controller
Before you can access the Lenovo XClarity Controller over your network, you need to specify how Lenovo XClarity Controller will connect to the network. Depending on how the network connection is implemented, you might need to specify a static IP address as well. - Set USB port for Lenovo XClarity Controller connection
Before you can access the Lenovo XClarity Controller through the USB port, you need to configure the USB port for Lenovo XClarity Controller connection. - Update the firmware
Several options are available to update the firmware for the server. - Configure the firmware
Several options are available to install and set up the firmware for the server. - Configure management port
Refer to the following section for more information on configuring management port. - Memory module configuration
Memory performance depends on several variables, such as memory mode, memory speed, memory ranks, memory population and processor. - PSU configuration
Refer to the following section for more information on the PSU configurations. - Deploy the operating system
Several options are available to deploy an operating system on the server. - Back up the server configuration
After setting up the server or making changes to the configuration, it is a good practice to make a complete backup of the server configuration. - Guidance on mixing trays configuration for the DW612S enclosure
Refer to the following section for more information on installing various direct water cooling trays into the DW612S enclosure.
Give documentation feedback