Skip to main content

Parts list

Use the parts list to identify each of the components that are available for your solution.

For more information about ordering parts:
  1. Go to Lenovo Data Center Support and navigate to the support page for your solution.

  2. Click Parts.

  3. Enter the serial number to view a listing of parts for your solution.

It is highly recommended that you check the power summary data for your solution using Lenovo Capacity Planner before purchasing any new parts.

Note
Depending on the model, your solution might look slightly different from the illustration.
The parts listed in the following table are identified as one of the following:
  • T1: Tier 1 customer replaceable unit (CRU). Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.

  • T2: Tier 2 customer replaceable unit (CRU). You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.

  • F: Field replaceable unit (FRU). FRUs must be installed only by trained service technicians.

  • C: Consumable and Structural parts. Purchase and replacement of consumable and structural parts (components, such as a filler or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

SD665 V3 parts list

Figure 1. SD665 V3 parts list
SD665 V3 parts list
Table 1. SD665 V3 parts list
IndexDescriptionType
For more information about ordering parts:
  1. Go to Lenovo Data Center Support and navigate to the support page for your solution.

  2. Click Parts.

  3. Enter the serial number to view a listing of parts for your solution.

1Tray coverF
2Rear cross braceF
3Power distribution boardF
4Water loopF
5DIMM combF
6DIMM toolF
7Memory moduleF
8Memory module fillerF
9DIMM coverF
10Conduction plate kitF
11System boardF
12ProcessorF
13ConnectX-7 NDR 400 thermal kitF
14ConnectX-7 NDR 200 thermal kitF
15Socket-direct interposer kit (for the interconnect cable)F
16SD665 V3 node miscellaneous kitF
17PCIe adapterF
18Riser cageF
19Drive cageF
20Drive cage with conduction plateF
212.5-inch drive (15 mm)F
222.5-inch drive (7 mm)F
23Front cross braceF
24Blank bezel filler without ventingF
25Blank bezel fillerF
26M.2 backplane assemblyF
27M.2 driveF
28CableF
29CMOS battery (CR2032)C
30SD665 V3 trayF
31ScrewF
32Gap pad kitF
33Miscellaneous Parts KitF
34SD665 V3 water loop Service KitF