Skip to main content

Install the dust filter in locking bezel

Use this information to install the dust filter in locking bezel.

Before you install the dust filter in locking bezel, complete the following steps:
  1. Read the following sections to ensure that you work safely.
  2. Turn off the server. Disconnect the power cords and all external cables (see Power off the server).

  3. Depending on the operation environment, check on the status of the dust filter at least every 3 months to make sure it is functional.

Procedure

  1. Align the dust filter with the slot in locking bezel, and place the filter into the slot.
    Figure 1. Dust filter installation
    Dust filter installation
  2. Rotate the dust filter holder into the slot until it clicks.
    Figure 2. Dust filter installation
    Dust filter installation
After you install the dust filter in locking bezel, complete the following steps:
  1. Install the node if needed (see Install a node).

  2. Reconnect power cords and all external cables.